![]() ![]() This indicates the rule is now active.įor getting FileZilla working in Sophos UTM, there isn’t a whole lot of configuration that needs to be done. Once you have finished building your DNAT, hit the Save button and your rule will look similar to the following:īe sure to slide the little “green” slider to the right so that it turns green. ![]() Be sure to select the Automatic Firewall rule as this will take care of the corresponding firewall rule to allow FTP traffic to and from your host. We then need to Change the destination to and here you will enter the IP address or network definition host that you have already built in this field. Then select your External WAN address for the Going to field. The service is FTP which you can use the built in service for this. You would setup your rule similar to the following:Īs you can see, we have traffic coming from Any since we are going to allow FTP traffic from any outside IP address. On the Sophos side, we can simply add a DNAT rule to pass traffic destined for the outside WAN address for the FTP service to change the destination to our internal server IP address. If you decide to turn off Windows firewall of course, you may skip the steps below. From the Windows Firewall side, we will create a couple of rules to encompass the FTP traffic and the passive ports. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |